Installer Menu Options i-on Range
Page 76
When you first power-up a new control unit (see the relevant Installation Guide), or if you
restore a control unit to factory defaults (see page 97 ), you must choose between having
a Part Setting system or a Partitioned system.
If you select a Part Setting system then the Installer Menu contains a “Setting Options” sub
menu. If you select a partitioned system then the installer menu contains “Partitions” sub-
menu instead.
Both of these menus contains the same options, but organised in slightly different ways:
The Setting Options sub-menu contains all the options to program entry, exit and alarm
response for a single alarm system with a Full Set and three Part Set levels.
The Partitions sub-menu contains an option for each partition. Each partition behaves like
a complete, independent, alarm system. However, each partition has only Full Set and
one Part Set.
Table 2 on the next page shows the layout of both the Setting Options and the Partitions
menus. Since so many of the options work in the same way in both of these menus, the
table shows the page number where the description of each option can be found.
Note: In a part setting system HUA Response appears in the System Options menu. In a
partitioned system HUA Response appears in each partition’s sub-menu.
Table 2. Setting Option and Partition Menus