Setting and Unsetting
Page 8
3. Depending on how the system is configured, the bottom line may
show the first of several setting options:
↕
Press or followed by to select the option you require:
Full Set (part-setting system only)
To set the whole system.
Part Set B\C\D (part-setting system only)
To set part set B, C or D only.
Note: Please refer to page 5 for details of part sets.
Full Set All (partitioned system only)
To set all partitions fully. This is available only if all
partitions are currently unset.
Partitions (partitioned system only)
To choose the partition(s) to set, and whether to full set or
part set those partitions.
Note: Please refer to page 5 for details of partitions.
4. If you selected Partitions:
a) The bottom line shows the name of the first partition to which
you have access and its current state (U = unset, S = full set,
PB/C/D = part set B/C/D is set):
↕
b) Press or to select the partition you want to set.
c) Press or to select the change you want:
↕
“U>PB/C/D” = change unset to part set B/C/D
“U>S” = change unset to full set
“S>U” = change set to unset
“PB/C/D>U” = change part set B/C/D to unset
Note: If a partition is full set, you cannot change it to part set or
vice versa; you must unset the partition first.
To Next Page
Loading...
Need help?
General
