Eaton i-on Series - Managing Remote Controls

User Menu Options
Page 52
Leave On Time, Off Time and Days without values if you
want the output to act as a simple on/off switch.
Press  when you have finished editing On Time/Off
Time/Days.
Managing remote controls
You can use System Config – Remotes to specify the functions that can be
carried out using remote controls. The System Config – Remotes menu
contains the following options:
Edit Used to edit the programming of the buttons, such as
the buttons used to set or unset the system, or operate
outputs.
Delete Deletes a selected remote control.
Delete All Deletes all remote controls.
Unset Enables or disables the ability for all remote controls to
unset the system.
HUA Function Enables or disables the ability for remote controls to
generate Hold-Up Alarms (HUAs).
These options are described next.
Editing the programming of the buttons
You can use System Config – Remotes – Edit to re-program the A, B or *
buttons on a one-way remote control, or the “*” button on a two-way remote
control, after the devices have been assigned to a user.
A button can be programmed to:
 Set a selected part set (in a partitioned system, it part sets only the
partition the remote control is assigned to).
 Operate an output configured as "User Defined" by the installer.
 Full set the whole system (one-way remote control only).
 Unset the whole system (partitioned system, one-way remote control
only).
 Full set or part set selected partitions (partitioned system, one-way
remote control only).