Eaton i-on Series User Manual

User Menu Options
Page 43
The keypad gives a double-beep confirmation tone and you will see
the results of the test:


The top line shows the name of the user the device is allocated to.
The bottom line shows the strength of the signal. If the signal strength
is less than 4, contact your installer.
3. Repeat step 2 for the other HUA devices.
4. Press  to end the test.
Testing proximity tags
Master and admin users can use Test – Prox Tags to test proximity reader
tags.
To carry out the test:
1. Select Test – Prox Tags.
The following is displayed:


2. Hold the proximity tag against the proximity tag sensor on the keypad.
The keypad gives a double-beep confirmation tone and you will see
the results of the test:


The bottom line shows the name of the user the proximity tag is
allocated to (or "Unknown" if the proximity tag is not recognised).
3. Repeat step 2 for the other proximity tags.
4. Press  to end the test.

Eaton i-on Series Specifications

General

Brand	Eaton
Model	i-on Series
Category	Security System
Language	English