User Menu Options
Page 50
Defining contacts
You can use System Config – Contacts to edit the Contacts List, which is a
list of up to 12 contacts (by default named Recipient A-L). Contacts are
used for outgoing communications, such as those for reporting alarms by
speech call or SMS message.
Note:
You cannot edit contacts that the installer has used for
communications to an Alarms Receiving Centre (ARC).
Unless you are sure of what you are doing, it is recommended that you
liaise with your installer before editing the Contacts List.
To edit the Contacts List:
1. Select System Config – Contacts.
The first recipient (contact) you are able to edit is displayed:
2. Press or followed by to select the recipient you want to edit.
3. Press or followed by to select one of the following options:
Name Select this to edit the name of the recipient. See
page 27 for details of how to enter text.
Tel No 1 The first telephone number of the recipient.
Tel No 2 The second telephone number of the recipient.
Note: The Email and IP Address settings are not used, as email
addresses (for emailed alarms) and IP addresses (for ARC reporting
over the internet) are configured and used by SecureConnect.
Press when you have finished editing the setting, and if required,
select another setting to edit.
4. Press several times to exit.
Editing outputs
You can use System Config – Edit Outputs to edit the on and off times of
any output the installer has configured as "User Defined".
Note: User-defined outputs can be activated or deactivated at any time
using Outputs On/Off (see page 56).
To Next Page
Loading...
Need help?
General
