User Menu Options
Page 31
allow you to change your own details, such as your access code. For some
user types, the Users menu is not available at all. The menu map on page
25 shows the user types that have access to Users menu, and the options
available. See page 34 for a description of each option.
Adding users
If you are a master or admin user, you can use Users – Add User to add
new users. When adding a new user, you can:
Specify the user's name, type, partitions (if applicable) and access
code. Each user must have a unique access code.
Assign a proximity tag, remote control and radio Hold Up Alarm (HUA)
transmitter (depending on user type − a shunt code user can have
only a proximity tag; duress and BMS users can have none of these
devices).
If you do not wish to assign these devices, most user types can assign
the devices to themselves at a later date using the Users option
(depending on user type – see the menu map on page 25).
A user can have only one proximity tag, remote control or HUA
transmitter. No two users can have the same device.
Note: The level-4 user can be created only by the installer. There can
be only one level-4 user.
To add a new user:
1. Select Users – Add User.
2. The next available default user name is displayed:
If you wish, edit this default name of the user (12 characters
maximum). If required, please refer to page 27 for details of how to
edit text. Press to continue.
3. The default user type is displayed (normal user):
Press or to select the user type (see page 2 for a description of
each user type). Press to continue.
To Next Page
Loading...
Need help?
General
