User Menu Options
Page 56
Enabling or disabling unsetting
You can use System Config – Remotes – Unset to enable or disable the
ability for all remote controls to unset the system. By default, remote
controls are able to unset the system, but you may want to change this for
security reasons.
After selecting Unset, use or to select Enabled or Disabled, followed
by .
Disabling Unset does not affect the ability for remote controls to set the
system.
Enabling or disabling HUA functions
You can use System Config – Remotes – HUA Function to enable or
disable the ability for a two-way remote control to generate Hold-Up Alarms
(HUAs).
Note: The installer must first enable this feature by configuring "Basic"
confirmation mode. Doing so means that the system does not comply with
BS8243 or DD243.
After selecting HUA Function, use or to select Enabled or Disabled,
followed by .
See page 14 for details of how to generate an HUA using a two-way
remote control.
Switching outputs on/off
Master and admin users can use Outputs On/Off to switch outputs on or off
as follows:
1. Select Outputs On/Off.
The display shows the first in a list of any outputs allocated for your
use. For example:
The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The
output type is displayed for control units that have built-in radio and
wired outputs. The bottom line shows the name of the output (which
may be the same as the address) and whether the output is currently
on or off.
To Next Page
Loading...
Need help?
General
