User Menu Options
Page 55
Output To operate a user-defined output. Use or followed by
to select the output, then use or followed by to
select the output mode:
On – Switches the output on.
Off – Switches the output off.
Toggle – Changes the state of the output each time
you press the button.
4. Press repeatedly to exit.
Deleting remote controls
You may want to delete a remote control if is lost or you want to reassign it
to another user. You must delete a remote control before you can reassign
it to another user.
The System Config – Remotes menu provides two options for deleting
remote controls:
Delete This allows you to delete a specific remote control (see
below).
Delete All This deletes all remote controls that the system learnt.
You should use this option only if you are sure you want
to delete all remote controls.
To delete a specific remote control:
1. Select System Config – Remotes – Delete.
The following is displayed:
2. Press the button on the remote control you want to delete.
Alternatively, if you do not have the remote control, press , then use
or to choose the remote control, followed by .
A message similar to the following is displayed:
3. Press to delete the remote control.
To Next Page
Loading...
