User Menu Options
Page 44
Testing ARC reporting
The Test – ARC Reporting option is available if the control unit uses a GSM
or PSTN module to communicate alarms to an Alarms Receiving Centre
(ARC).
Master and admin users can use Test – ARC Reporting to test the
connection to the ARC.
To carry out the test:
1. Select Test – ARC Reporting.
The following is displayed:
2. Use or to choose one of the two recipients selected by the
installer. Each recipient uses a separate telephone number to the
ARC. Depending on how the installer has configured
communications, the second line may be used if the first fails to
connect.
3. Press to start the test.
The keypad shows the progress of the call. Check with the ARC that
the test call arrived. If the call fails, the display shows “Call failed”,
followed by the reason.
System configuration
The System Config menu allows you to change some parts of the system
to suit your particular needs.
Note: The menu map on page 25 specifies the options available for each
user type.
Switching facilities on/off
System Config – Facilities On/Off can be used to switch the following
facilities on or off:
Chime Use this option to enable or disable the chimes that
occur when a zone is triggered that has a Chime
To Next Page
Loading...
