Setting and Unsetting
Page 17
C – To set part set C (part-setting system) or to set partition 3.
D – To set part set D (part-setting system) or to set partition 4.
4. You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 6 on
page 9 (except there is no keypad display).
Unsetting from an i-RK01 radio keypad
1. Enter through the entry route designated by the installer.
2. Go directly to the keypad, since you will have limited time to unset the
system before it generates an alarm.
3. Enter your access code or present your proximity tag to the keypad.
4. Press .
Using a two-way KEY-RAS keypad
Note: Please refer to the KEY-RAS User Guide for full information about
how to use the KEY-RAS.
A two-way KEY-RAS keypad (Figure 5) can transmit to the control unit and
receive information back from the control unit. The keypad can show the
current set/unset status of the system, and sound entry, exit and alarm
sounds.
Figure 5. Two-way KEY-RAS radio keypad
Setting from a KEY-RAS radio keypad
1. Make sure the system is in standby.
2. Key in your access code, or press the ? key and present your
proximity tag.
To Next Page
Loading...
