Eaton i-on Series - Page 57

User Menu Options
Page 53
 Unset selected partitions (partitioned system, one-way remote control
only).
Note for one-way remote controls:
 If you have a part-setting (non-partitioned) system, you cannot
reprogram the unset button.
 If you have a partitioned system, the unset button can only be used to
unset some or all partitions allocated to the user. See Unset, Unset All
and Unset, Partitions below.
To re-program the buttons on a remote control:
1. Select System Config – Remotes – Edit.
The following is displayed:


2. EITHER:
a) Press the button on the remote control you want to re-program.
Hold down the button until you see the transmit LED flash.
OR (if you do not have the remote control):
a) Press  at the "Press Remote Button" prompt.
b) Use  or  followed by  to select the remote control you
want to re-program.
c) The display lists the first button on the remote control:


d) Use  or  followed by  to select the button you wish to re-
program.
The top line of the display shows the identity of the remote control, the
button you pressed or selected, and the name of the owner. For
example:


3. Use  or  followed by  to choose the function for the button: