Communications Menu
Page 82
If you selected Fast Format in Report Type, you can use Fast Fmt Channels to allocate an
event to each of eight channels. Table 6 shows the default events for each channel. Table
7 and Table 8 show the events available. You can key-in the two-digit numbers shown
next to each event in order to display that event type.
Table 6: Fast Format Channel Factory Defaults
Table 7: Fast Format Events (UK Systems)
15. Zone Omit (Setting) (see note 2)
09. RF Supervision (see note 4)
10. RF Jamming (see note 4)
11. Mains Fail (see note 5)
27. Burg Alarm P1 (partitioned system only)
.. up to the maximum number of partitions
Table 8: Fast Format Events (EU Control Units)
15. Zone Omit (Setting) (see note 2)
09. RF Supervision (see note 4)
10. RF Jamming (see note 4)
To Next Page
Loading...
Need help?
General
