What does it mean if the green LED is on and the red LED flashes at 2Hz on my Eaton Matrix Telecom System Inverter, while the AC output is normal?
This indicates either an SCR short fault or an auxiliary power supply fault. Turn the MBS to mains or inverter bypass mode to maintain the STS.
What does it mean if the red LED is on and other LEDs are off, while AC output is off on my Eaton Matrix Telecom System?
This could mean several things: * The STS is in fault mode. * There is an over-temperature condition. * There is an overload. * There is an output short. Turn the MBS to mains or inverter bypass mode to maintain the STS. Check if the environmental temperature is higher and if anything is blocking the vent. Decrease or remove the loads, then shut down or remove the STS module. Then connect it back and restart it up.
General| Battery Voltage | 48 VDC |
|---|---|
| Output Voltage | 120 VAC |
| Form Factor | Rackmount |
| Frequency | 60 Hz |
| Efficiency | 90% |
| Operating Temperature | 0°C to 40°C |
Describes the integrated AC power system, its modular design, and redundancy.
Details the Inverter Module and Controller Module, including features and components.
Details safety measures for handling, charging, and disposing of batteries.
Specifies electrical connection requirements, including grounding and symbols.
Covers the assembly of inverter, controller, STS, and MBS chassis.
Explains procedures for connecting DC input and AC output cables.
Describes how to install and remove STS and inverter modules.
Lists essential checks before powering on the inverter, STS, and controller.
Details the steps for applying power to the system and initial checks.
Explains how to monitor system status via the controller's LCD screen.
Guides on setting system parameters, including password protection.
Provides tables for diagnosing and resolving system issues.
Lists alarm codes for Inverter, Controller, and STS modules.
To Next Page