Eaton SM65 - Viewing and Editing Configuration File Parameters

Operation
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
13
► To view system status messages
1 Press : to enter Status View Mode.
If there are active alarms, press 6 to scroll to the bottom of the alarm list. The control
status list is displayed after the last alarm.
2 Press 6 or 7 to scroll through the list of status messages.
3 Press 9 to return to Main Display Mode.
Viewing Software Version
► To view the SM65 software version using the keypad
1 Press : to enter Status View Mode.
 If there are active alarms, press 6 to scroll to the bottom of the alarm list. The control
status list is displayed after the last alarm.
2 Press 6 to scroll to the Identity screen to view the software version of the SM65.
3 Press 9 to return to Main Display Mode.
► To view the SM65 software version using DCTools
1 Start DCTools (refer to the Communications Options on page
30).
2 From the DCTools System Summary (Home) screen, go to Configuration > Identity.
Viewing and Editing Configuration File Parameters
Configuration Mode displays only those configuration file parameters that are most likely to
be changed on-site. These parameters can be changed in Edit Mode.
For viewing and editing all other configuration file parameters a laptop computer or remote
access is required. See Communications Options on page
30 for details.
► To view and edit a configuration file parameter
1 From Main Display Mode, press 8 to enter Configuration Mode.
2 Press 6 to scroll down to the required parameter.
3 Press 8 to enter Edit Mode.
 If access to Edit Mode is not available then see Keypad Access Security on page 10.
4 Press either 7 or 6 to change the value as appropriate.
5 Press 8 to save the new value and return to Configuration Mode, or
6 Press 9 to cancel the change and return to Configuration Mode.
7 Press 9 to return to Main Display Mode.