Eaton SM65 - Replacing an SM65 mounted in a slider magazine

Maintenance
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
45
Replacing an SM65 mounted in a slider magazine
Before you start, you need
• A PC with the DCTools software installed.
• A copy of the appropriate SM65 configuration file, which can be one of the following -
the old configuration file, a backed-up configuration file or a modified default
configuration file.
• A null modem cable.
Step 1 - Set any LVD controllers to Manual Connect

To prevent an accidental operation of an LVD contactor (and disconnection of
the battery or load equipment) set any LVD controllers to Manual Connect.
 Refer to the DC power system Installation Guide for information on how to set
the LVD Auto/Manual selector switch.
Step 2 - Withdraw the old SM65 from the rack

1 Loosen the locking screw.
2 Press the two latches and pull the SM65 out.