Eaton SPD Series for Mounting External to Electrical Distribution Equipment Installation Manual IM01005031E—Rev 09 23
6. On the General tab, select Use the following IP address:
a. Enter 192.168.1.10 for the IP Address.
b. Enter 255.255.255.0 for the Subnet Mask.
c. Enter 192.168.1.1 for Default gateway.
7. Click on OK button and then exit out of all these open windows.
55..33 PPoowweerr XXppeerrtt SSPPDD NNeettwwoorrkk CCoonnnneeccttiioonn
Set up the SPD network connection as follows:
Power Xpert SPD User Setup
To Next Page
Loading...
