7.3.1.2. Delay [ms]
This parameter means minimum time for change maintenance at input so that it
would be detected by transmitter. Factory setting is 400ms.
7.3.1.3. Lock
With this option you can lock any input of module, and as a result condition
changes on this input will be ignored and will not be reported to monitoring station.
Lock may be persistent or temporary.
In case of temporary lock – user can set lock time and number of input state
changes after which lock occurs. Lock time is counted from first input state change.
More detailed information about input locks is shown on a diagram.
To Next Page
Loading...
