7.10. FIRMWARE
The device is equipped with built in bootloader that allow for updating and change of
firmware. During programming all information is displayed in respect of carried out
operation.
Follow the following procedure:
a) Launch configuration program
b) Open “Firmware” option of configuration wizard
c) Open file with new firmware (click [Open] button to locate where file is).
d) Select file transmission mode: local or remote.
Note: Procedure of assigning firmware to a device is analogous to
programming a device. For procedure refer to chapter 8 Programming of
the device.
e) Click [Start] button to start software exchange.
f) Loading course is displayed on special window.
g) Close the window after completed saving
From this time on the device will work under control of new firmware.
Note : The above procedure shall be carry out with due care to avoid
improper device operation.
To Next Page
Loading...
