EBS PX200N - Old Protocol

PX200N_Manual_en-1.11i7 Page 53 / 58
9.2. OLD PROTOCOL
The following format of message is acceptable allowing to send some commends
with one SMS (every command shall be separated with SPACE):
SERVICE CODE █ COMMAND █ COMMAND █ ..........
Where:
SERVICE CODE - device service code
█ - SPACE
COMMAND - order (see the table below)
List of commands
NEW Switch device operating in PX emulation mode into encoding
protocol mode.
STAT Enquiry regarding actual module condition
VER Gets device firmware version
TMP1 Switches on OUT1 output
TMP0 Switches off OUT1 output
AUX1 Switches on relay output
AUX0 Switches off relay output
INT_ON TMP (sabotage) input lock
IN1_ON 1 input lock
IN2_ON 2 input lock
IN3_ON 3 input lock
IN4_ON 4 input lock
IN5_ON 5 input lock
IN6_ON 6 input lock
IN7_ON 7 input lock
IN8_ON 8 input lock
INA_ON All inputs lock (with no impact on sabotage input)
INT_OFF TMP (sabotage) input unlock
IN1_OFF 1 input unlock
IN2_OFF 2 input unlock
IN3_OFF 3 input unlock
IN4_OFF 4 input unlock
IN5_OFF 5 input unlock
IN6_OFF 6 input unlock
IN7_OFF 7 input unlock
IN8_OFF 8 input unlock
INA_OFF All inputs unlock (with no impact on sabotage input)
KILL GSM modem reset