Ecolab Elados EMP IV E00 - Safety; Intended Use; General Safety Information

417101090_EMP_IV_E00_E10
- 35 -
Rev. 8-06.13
2 Safety
CAUTION
Safety warnings and emphases must be observed in all cases!
ATTENTION
2.1 Use as intended
ATTENTION
The EMP IV may only be used in conjunction with products validated by Ecolab. Liability is
not accepted if products are used which have not been validated!
The metering pump is suitable for clean, non-abrasive metering media with a viscosity of up
to 100 mPas (measuring method: Brookfield).
The EMP IV has been developed, designed and built exclusively for industrial and
commercial use. The system is not intended for private use.
Use as intended also includes compliance with the control and operating instructions
prescribed by the manufacturer, as well as with the maintenance and servicing conditions.
The service life of the metering unit is approximately 8 years, provided the system is properly
maintained. It then needs to be inspected
(followed by a general overhaul, if necessary) by the manufacturer or by a specialist firm.
2.2 General safety information
• The metering medium supply must be shut off before any repairs are carried out.
• All connection and repair work on the EMP IV may only be conducted by authorised and
trained specialist personnel.
• It is imperative that all work on electrical parts is undertaken with the mains plug
unplugged.
• Suitable protective clothing must be worn during maintenance and repair work.
• Safety regulations covering the handling of chemicals must always be observed.
• The EMP IV may only be operated with a 230 V AC supply voltage and a 24 V control
voltage.
2.3 Safety measures (to be carried out by the owner)
It is expressly up to the owner:
• to instruct its operating and maintenance personnel about safety features of the EMP IV;
• to monitor their compliance with safety measures;
The frequency of inspections and controls must be complied with.
The procedures described here must be set out to make sense
• to a trained person in the sections on Operation
• to a specialist in the sections on Transport, Setup and Installation, Maintenance, and
Troubleshooting. Procedures described in these sections may only be performed by
specialist personnel.
2.3.1 Trained person
A person who receives instructions and, where necessary, training from a specialist about
the duties which are assigned to him or her and about the possible hazards of incorrect use
and who has been advised about the necessary safety features and measures.