417102012_LMI02.doc - 70 - Rev. 9-07.08
7.1.2.2 Displays in CIP mode
With no activation of limit values for SP1 and SP2 (for “OFF” setting)
The activation of limit values SP1 and/or SP2 is indicated by the respective number (SP1
above left, SP2 above right)
The switching on of relay SP1/SP2 is indicated by a triangle (▲) before or behind the
respective number.
NOTE
In CIP mode, the metering enable, the pre-metering and the pre-metering delay time are
not activated.
7.1.2.3 Display when instrument is switched off
The control f
unction can be switched off by simultaneously pressing the
▲, ▼ and ↵ keys
for 5 seconds.
The actual conductivity and temperature value continue to be displayed.
Press any key to restart the instrument.
To Next Page
Loading...
