Ecolab LMI03 - Page 129

Conductivity/concentration
The Conductivity/Concentration submenu appears only if a product name has
already been assigned.
3.
Press .
ð
The ‘Conductivity/ Concentration
’ screen (21) appears.
4.
Select parameters or ‘Product
’ using
, or select and confirm with
.
ð
Conductivity/concentration is set.
Product name
The Assign Product Name submenu appears only if a product name has not
yet been assigned.
5.
Press .
ð
The ‘Product Name
’ screen (22) appears.
6.
Set the product name using , and , and confirm with .
ð
Product names are assigned.
Installation and start-up
45 MAN049432 Rev. 03-03.2024