7.3.2 Configure outputs
Controller settings for setpoints 1 and 2
Control of post-proportioning with proportioning time limit using relay outputs.
Controller settings
Starting point: ‘Options’ screen (12)
Ä
Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Settings
’
(13) and confirm with .
2.
Select ‘Controller Settings for Setpoints 1 and 2
’ (50) and confirm with
.
3.
Set controller settings setpoints 1 and 2 using , and .
4.
Confirm the settings with .
ð
Controller settings for setpoints 1 and 2 are set.
Additional settings in the Controller Settings for Setpoints 1 and 2 submenu
n Pre-proportioning Delay Time and Proportioning Time (51)
Ä
‘Pre-proportioning delay
time and proportioning time’ on page 52
Installation and start-up
51 MAN049432 Rev. 03-03.2024
To Next Page
Loading...
