7.3.3 Alarms
Alarm delay for empty detergent
Available only in conductivity mode.
Sets the time after which the alarm is triggered.
Starting point: ‘Options’ screen (12)
Ä
Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Settings
’
(13) and confirm with .
2.
Select ‘Alarm Settings
’
(60) and confirm with .
3.
Set the alarm delay in seconds using , and .
4.
Confirm the settings with .
ð
Alarm delay for empty detergent is set.
Additional settings in the Alarm submenu
n Maximum proportioning time exceeded (61)
Ä
‘Maximum proportioning time
exceeded’ on page 54
n Alarm delay for high detergent concentration (62)
Ä
‘Alarm delay for high detergent
concentration’ on page 55
Installation and start-up
53 MAN049432 Rev. 03-03.2024
To Next Page
Loading...
