n Alarm delay if the minimum temperature is not reached (63)
Ä
‘Alarm delay if the
minimum temperature is not reached’ on page 56
n Alarm repeat time (64)
Ä
‘Alarm repeat time’ on page 57
To switch between the individual submenus, press
repeatedly.
Maximum proportioning time exceeded
Starting point: ‘Settings’ screen (13)
Ä
Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Alarm Settings
’
(60) and confirm with .
2.
Press until the ‘Maximum Proportioning T
ime Exceeded’ screen (61) appears.
ð
The ‘Maximum Proportioning Time Exceeded’ screen appears
3.
Set the delay in seconds using , and .
4.
Confirm the settings with .
ð
Proportioning timeout set.
Installation and start-up
54MAN049432 Rev. 03-03.2024
To Next Page
Loading...
