Ecolab LMI03 - Manual Operation

8.3 Manual operation
The ‘Manual Operation
’ menu can be used to switch the manual outputs of the LMI03 on
and off manually.
The following options are available:
- Outputs
- Pre-proportioning
- Alarm
Starting point: ‘Options’ screen (12)
Ä Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Manual Mode’ and confirm with .
2.
Use to select the desired output, or to activate the desired output
and press to confirm.
ð
The corresponding output is switched on.
To switch off the output, confirm it again with .
Operation
68MAN049432 Rev. 03-03.2024