Pre-proportioning delay time and proportioning time
Setting of delay time and proportioning time for pre-proportioning using relay outputs.
Starting point: ‘Settings’ screen (13)
Ä
Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Controller Settings for Setpoints 1 and 2
’ (50) and confirm with
.
2.
Press until the ‘Pre-proportioning Delay T
ime and Proportioning Time’ screen (51)
appears.
3.
Set pre-proportioning delay time and proportioning time via , and .
4.
Confirm the settings with .
ð
Pre-proportioning delay time and proportioning time are set.
Installation and start-up
52MAN049432 Rev. 03-03.2024
To Next Page
Loading...
