Temperature compensation
The conductivity changes depending on the temperature of the solution to be determined.
A temperature sensor installed in the measuring cell compensates for the influence of
temperature on the measurement result.
Starting point: ‘Settings’ screen (13)
Ä
Chapter 7.1 ‘Initial start-up’ on page 43
1.
Select ‘Conductivity Measuring Cell
’
(40) and confirm with .
2.
Press until the ‘T
emperature Compensation’ screen (41) appears.
3.
Set the temperature compensation using , .
4.
Confirm the settings with .
ð
T
emperature compensation is set.
Installation and start-up
50MAN049432 Rev. 03-03.2024
To Next Page
Loading...
