12.1 Internal
(Go to Adjustments > Internal)
Print contrast
Choose print contrast from 0-9
Reload function
Choose remote unit battery recharging
settings (see 5. Power Supply)
Key beep
Press F1/F4 to turn key beep on/off
Graphic menu
Press F1/F4 to turn graphic menu on/off
Probe heating
Press F1/F4 to turn probe heating on/off
for soot measurement test (see 8.3 Soot
Measurement Test)
Power saving mode
Press F1/F4 to turn on/off power saving
mode, which turns off the Peltier cooler
and the heated probe option
Language: English
Press OK to choose between French and English
F1 Hotkey
Press Up/Down to choose F1 shortcut (see 8.1 Gas Analysis)
F4 Hotkey
Press Up/Down to choose F4 shortcut (see 8.1 Gas Analysis)
Eff.(C)
Press F1/F4 to turn on/off the efficiency calculation with and with-
out condensation
RF-connect
*Do not change from default setting unless you are troubleshoot-
ing communication issues! (See 6. Radio Communication)
-Standard: choose this option to sync the base and remote units
if radio communication problems occur
-RF-connection: do not choose this option
-Remote: default setting
*Change RF-connect setting back to Remote after troubleshooting.
To Next Page
Loading...
