Ecotechnics Cinquecento12 - Page 87

The data, information and descriptions, and the technology described herein are the exclusive intellectual property of Snap-on Climate Solutions S.r.l. and
constitute industrial secrets. Said information is communicated in strict confidentiality; said information may be used only for the purpose for which it is
communicated; said information may not be divulged, communicated, or revealed to third parties and/or reproduced by any means for any reason whatsoever; said
information is protected under applicable Italian competition and industrial property law.
Service manual Cinquecento12 (VA21) [MANUY2V.SB0] ed.1 ver.0.1.doc pag.87 - 09/11/2021
*ERROR*
*CAUSE*
*SOLUTION*
Power cable not inserted correctly
Check the insertion in the wall
socket and in the switch on the
back side of the machine.
Power cable crushed, damaged or
cut.
Replace the power cable
Cable connected to slippers or
multiple sockets
Remove the extension cable
and connect the cable directly
to the wall socket
Blown fuse
Replace the main fuse (1) with
spare fuse (2) . The Fuse is 8A
The fuse continues to burn
Board or power supply short
circuit problem.
Open the operator panel and
check the board and power
supply if are light on.
Replace it or contact the
Technical Assistance
Power supply with led off
Check if the power supply has
led on. If it is off, replace it
and check the input line fuse
again.
1
2
THE MACHINE
DOES NOT TURN
ON
THE MACHINE
DOES NOT TURN
ON