from the power adapter to ensure best RF reception from the outdoor
sensor package.
Note: The console can store historical data on a memory card. This memory card
is not included. If you want to use one you will need a microSD memory
card. The supported max capacity of the card is 32G(Format: FAT32). A
1GB card will store more than 10 years’ data. There is also no requirement
on the speed class of this card as data writing happens infrequently and is
not speed critical.
Note: Batteries for the ultrasonic anemometer and the rain gauge sensor are not
included. You will need 2 AA size Lithium battery for the ultrasonic
anemometer, which is primarily for startup and backup purpose. After
setup and during normal operation, the unit is getting its power from solar
cell. One AA size battery, alkaline or Lithium (recommended for colder
climates) is required for the rain gauge. Two AA size alkaline batteries are
required for the indoor sensor.
Note: There are two sets of U-bolts in the box, one is for the ultrasonic
anemometer sensor and the other one is for the rain gauge sensor. There’s a
short stainless-steel tube included for the rain gauge sensor installation.
Note: The rain gauge can also be mounted to a surface using two screws, so the
included stainless-steel tube is not always necessary!
To Next Page
Loading...
