What to do if the output sensor is dirty in ECRM Mako 4 CTP All in One Printer?
If the output sensor of your ECRM All in One Printer becomes dirty, gently rub the output sensor with a cotton tip swab moistened with isopropyl alcohol to remove any debris buildup.
How to clean dirty rollers on ECRM All in One Printer?
To clean the rollers of your ECRM All in One Printer, use the User Maintenance Menu and sparingly apply 'Fantastik' and isopropyl alcohol.
What to do if misfeed occurs in ECRM Mako 4 CTP?
If a misfeed occurs in your ECRM All in One Printer, and a plate gets 'hung up' in the machine, do not raise the pinch roller bar. Instead, use the PREV and NEXT buttons to extract the plate.
How to clean the filter of ECRM Mako 4 CTP?
To clean the filters of your ECRM All in One Printer, especially when they show signs of contamination with dust or other debris: * Wash the filter in mild, soapy water. * Rinse it in clean water. * Dry the filter. Repeat these steps to clean the other filter.
Details system requirements and safety precautions for operating the Mako 4 CTP.
Explains how to operate the Mako 4 CTP system, including its components and procedures.
Provides instructions for loading, unloading, and managing media with the Mako 4 CTP.
Guides users through routine maintenance tasks and common troubleshooting solutions.
General| Wavelength | 830 nm |
|---|---|
| External Drum | Yes |
| Technology | Thermal |
| Plate Thickness | 0.15 - 0.30 mm |
| RIP Compatibility | Harlequin RIP |
To Next Page