2 - 22 AG45134 Rev. 3
Error Messages
During operation, error conditions may occur that require your
intervention. These messages will appear on the system display
panel and the error indicator LED will light. Additionally, if
enabled, the alarm will also sound.
Operator-Correctable Errors
The error messages that you can clear are listed below.
COVERS ARE NOT SECURE - This error is displayed when one
of the system covers are not secure. Locate and close the open
cover, and then
OPERATOR ABORT - This error is displayed when the operator
aborts a job by using the ‘stop’ button on the control panel.
LASER IS OVER TEMPERATURE - Alerts you that the laser is
over temperature. If you override this error in the User Preferences
Menu, the laser life will be shortened.
IMAGE OFFSET ERROR, INCOMPATIBLE PARAMETERS -
This error is displayed when the combination margin, resolution,
magnification, media width, and image offset result in a condition
where the image starts before the laser can activate. If you should
encounter this error, minor adjustments to the above parameters, to
push the image to the center of the plate should resolve the problem
PINCH LEVER OPENED WHILE MOVING MEDIA - This error
is displayed if the pinch lever bar is raised while a plate is moving
through the machine.
Correcting Errors
Step 1. If a plate is in the machine when the error occurs, remove the
plate as explained in Maintenance and Troubleshooting.
Step 2. Correct the condition that caused the error.
To Next Page
Loading...