ECRM Mako 4 CTP - Organization of this Guide

AG45134 Rev. 3 v
Preface
Scope of this Guide
This guide provides instructions for the operating and maintaining a
Mako 4 CTP platesetter. This guide describes all aspects of the
operation of the system, from the loading of media, to the delivery
of exposed media to an on-line processor.
The Mako 4 CTP employs a Class 3B laser. This guide contains
important safety information and regulatory information about the
laser. You should read this information thoroughly before operating
the system or performing the procedures described in this guide.
This guide assumes that the system is already properly installed and
plugged into the AC mains. Further, this manual assumes that the
system has been calibrated and tested for proper operation and
acceptable output. Only procedures necessary for safe and efficient
operation are provided in this manual.
Organization of this Guide
Chapter 1: Requirements and Safety
Chapter 1 includes system operating requirements and information
about laser safety.
Chapter 2: System Operation
Chapter 2 discusses all operational features and provides complete
listings of system operational messages. All of the system menus
are described in detail. All of the menu items are mapped in flow
diagrams.