2 - 14 AG45134 Rev. 3
Test Patterns Menu
The test pattern menu is used to select and run one of the pre
programmed test patterns. (See the “TEST PATTERN
SELECTIONS” sidebar in Figure 2-2-8 on page 15 for a list of the
test patterns).
The test pattern menu configuration options are summarized below.
Note: Some of options listed below are test- pattern specific.
TEST PATTERN MODE
OPTIONS Enabled or Disabled
This option moves the system in and out of test pattern mode.
TEST PATTERN TYPE
OPTIONS List of Test Patterns
Test Patterns are described fully in the system Reference guide
and are for the use of qualified technicians only.
REVERSE IMAGE POLARITY
OPTIONS YES or NO
This option will reverse the test pattern images. YES will expose
the background of the plate. NO will expose the image area.
BAR WIDTH
OPTIONS 1 to 999999 Pixels
This parameter specifies the width of the lines in the Bar Test
Patterns.
BAR SPACING
OPTIONS 1 to 999999 Pixels
This parameter specifies the width of the spaces between the
lines in the Bar Test Patterns.
To Next Page
Loading...