EDAN DUS 60 - Connection of Auxiliary Devices

DUS 60 Digital Ultrasonic Diagnostic Imaging System Service Manual
- 39 -
where RF gaskets
touch metal
created will permit RF leakage. Or, if a label has been found in such a
position, move the label.
Use EDAN specified
harnesses and
peripherals
The interconnecting cables are grounded and require ferrite beads and
other shielding. Also, cable length, material, and routing are all important;
do not change from what is specified.
Take care with cellular
phones
Cellular phones may transmit a 5V/m signal; that could cause image
artifacts.
Properly dress
peripheral cables
Do not allow cables hang out of the peripheral bays. Loop the excess
length for peripheral cables inside the peripheral bays. Attach the monitor
cables to the frame.
Table 3-3 EMI Prevention/Abatement
3.4. Connection of Auxiliary Devices
Figure 3-1 Connection of Peripherals
Device Manufacturer Model Video Signal
Video printer SONY UP-895MD
PAL/ NTS C
Video printer SONY UP-897MD
PAL/ NTS C
Video printer MITSUBISHI P93W
PAL/ NTS C
USB printer HP DeskJet D2368 USB-Port
USB printer HP DeskJet D2568 USB-Port
USB printer HP DeskJet D4368 USB-Port
USB printer HP LaserJet P2015 USB-Port
USB printer HP LaserJet P2035 USB-Port
USB printer HP DeskJet D5568 USB-Port
USB printer HP DeskJet D2668 USB-Port
Table 3-4 Approved Peripherals