Why is there no CO waveform on my EDAN Medical Equipment?
If there is no CO waveform on your EDAN Medical Equipment, there may be a bad connection of the CO module. Power off the device and reconnect the CO module. If the problem persists, the CO module may be defective and require replacement.
What to do if EDAN iM80 Monitor displays 'PULSATILE PRESSURE ZERO FAIL'?
If the EDAN Monitor displays 'PULSATILE PRESSURE ZERO FAIL,' ensure the transducer is vented to air and not connected to a patient. Then, try again.
What to do if EDAN iM80 displays 'Art ZERO FAIL'?
If the EDAN Monitor displays 'Art ZERO FAIL', make sure that the transducer is not attached to the patient.
What to do if EDAN Monitor displays 'Art SENSOR OFF, FAIL'?
If the EDAN Monitor displays 'Art SENSOR OFF, FAIL', ensure the transducer is not off, and then proceed with zeroing.
Why is the AG waveform smooth on my EDAN Medical Equipment?
If the AG waveform is smooth on your EDAN Medical Equipment, the GAS module is likely in Standby mode. Change the mode from Standby to Measurement mode.
Why is there no NIBP numeric value on my EDAN Medical Equipment?
If there's no NIBP (Non-Invasive Blood Pressure) numeric value displayed on your EDAN Medical Equipment, it could be due to a loose cuff or patient movement. Make sure the cuff is properly secured and ask the patient to remain still.
What causes fuses to blow after switching on EDAN Medical Equipment?
If the fuses are blown after switching on your EDAN Medical Equipment, further examination after switching on is required to identify any short circuits in the power or other parts.
Why is there no audible alarm on my EDAN Medical Equipment?
If no audible alarm is activated on your EDAN Medical Equipment, first ensure that the audible alarm is not temporarily disabled and switch it on if necessary. If the alarm is enabled but still not working, the loudspeaker or the wire may be defective, requiring replacement.
What to do if EDAN Medical Equipment LCD is black, power is on, and the fan runs?
If your EDAN Medical Equipment's LCD has no display but the power indicator is lit and the fan runs, check if the keys sound properly. If they do, the LCD might be defective. However, if the keys don’t sound, the main control board might be the problem, and you should replace it.
Why is the touch screen not working on my EDAN Medical Equipment?
If the touch screen on your EDAN Medical Equipment isn't working, first check if it's disabled in the system setup and enable it if necessary. Then, ensure that the cables between the keyboard and touch screen are securely connected. If these steps don't resolve the issue, the touch screen may be damaged and require replacement.
General| Display Type | TFT LCD |
|---|---|
| Respiration | Yes |
| SpO2 | Yes |
| NIBP | Yes |
| Temperature | Yes |
| Pulse Rate | Yes |
| EtCO2 | Optional |
| Battery | Rechargeable lithium-ion battery |
| ECG | 3/5 lead ECG |
| Optional Parameters | Cardiac Output |
| Networking | Wi-Fi, Ethernet |
| Weight | 2.5 kg |
To Next Page
