iM80 Patient Monitor Service Manual Disassembling the Monitor
- 38 -
Chapter 8 Disassembling the Monitor
WARNING
1 Only qualified service personnel shall open the monitor housing.
2 Switch off the monitor and disconnect it from AC power before disassembling the
monitor.
3 After any repair of the device, perform safety tests prior to use.
8.1 Tools Required
8.2 Replacing Fuses
To replace the melted fuses,
1. Switch off the monitor and disconnect it from power.
2. The back of the monitor should face the operator.
3. Pull out the fuse box and pick the inside fuse up with a flat-head screwdriver.
1 – A cross-head screwdriver
2 – A flat-head screwdriver
3 – A M3 nut driver
4 – A pair of pliers
To Next Page
Loading...
