Eddyfi Technologies INUKTUN VERSATRAX 100 User Manual

Versatrax 100™
Document: UMDT013103.docm
Revision: A13
Created by: KJB
Date: 15 Oct 2019
3070984-A13
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Page 17 of 47
User Manual
SubConn Connector: Lubrication and Cleaning
• Periodically apply Molykote 111 silicone grease or equivalent before mating connectors
• For dry mate connections, a layer of grease corresponding to 1/10 the socket depth should
be applied to the female connector
• After greasing, fully mate the male and female connector and remove excess grease from the
connector joint
• General cleaning and removal of sand or mud on a connector should be performed using a
spray-based contact cleaner like isopropyl alcohol
Impulse Connector: Lubrication and Cleaning
• Lubricate mating surfaces regularly with 3M Silicone spray or equivalent, DO NOT GREASE
• Lubricate O-rings with Molykote 111 or equivalent
• Use dust caps to protect connectors wherever possible
• Clean connectors with soap and fresh water, rinse out with alcohol and allow connector to air
dry before using.

Eddyfi Technologies INUKTUN VERSATRAX 100 Specifications

General

Brand	Eddyfi Technologies
Model	INUKTUN VERSATRAX 100
Category	Robotics
Language	English