Document: UMDT013103.docm
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Precautions
IMPORTANT: When configuring a 70V system, check to see if the tracks are
compatible. Older versions of 4000 series Microtracs™ are not 70V
compatible. Look for the Wide Input Voltage symbol \V/ located on the side
plate of the track indicating 70V compatibility.
Certification
The Versatrax 100™ system is built in accordance with the Low Voltage Directive 2014/35/EU, Machinery
Directive 2006/42/EC, and Electromagnetic Compatibility Directive 2014/30/EU.
Safety
To use this product properly and safely, every user must first read these operating instructions and
observe the safety instructions contained therein. Take care of these operating instructions and keep
them in a place where they can be accessed by everyone. Untrained personnel should not handle or
operate this equipment.
CAUTION: Failure to follow these safety instructions may result in injury or
equipment damage.
WARNING: Hazardous Voltage 36-70 VDC. If the equipment is powered from a
source other than an Eddyfi Inuktun provided controller, the power supplied to the
product must have reinforced isolation from the mains with no reference to earth
ground.
WARNING: Magnetic Pinch Hazard – The magnetic
chassis is fitted with rare earth magnets. These magnets
are very strong and create an immanent pinch hazard.
Use caution when handling the magnets or vehicle near
steel objects and tools, they may snap together
unexpectedly.
WARNING: Medical Hazard – Operators with
magnetically sensitive medical implants should be aware
of and follow appropriate practices.
WARNING: Electronic Device Interference –
Magnetically sensitive devices, including computer hard
drives, cell phones, watches and credit cards may be
To Next Page
Loading...
Need help?
General