Document: UMDT013103.docm
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Post-Operations Check
A Post-Ops inspection should be carried out after every deployment using the following checklist:
❑ Inspect the tether for damage as it is reeled in.
❑ Visually inspect vehicle for entrained debris or mechanical damage.
❑ Test each function to ensure proper operation.
❑ Clean the system by hosing it down with water at regular line pressure. Do not pressure wash. The
tracks may be cleaned off by hosing them down while running. If the system has been used in salt
water, thoroughly rinse the vehicle with fresh water right away.
CAUTION: Do not use a pressure washer to clean the camera. Very high-
pressure water can push past seals and flood the camera resulting in electrical
damage or personal injuries.
❑ Take time to pack the system properly for transport away from the worksite.
❑ Store the system in a dry environment.
Note: Ensuring the Versatrax 100™ system is always stored in good working condition will minimize
deployment time for future inspections.
To Next Page
Loading...
Need help?
General