Chapter 8
| Authentication Commands
PPPoE Intermediate Agent
– 303 –
pppoe
intermediate-agent
This command enables the PPPoE Intermediate Agent globally on the switch. Use
the no form to disable this feature.
Syntax
[no] pppoe intermediate-agent
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† The switch inserts a tag identifying itself as a PPPoE Intermediate Agent
residing between the attached client requesting network access and the ports
connected to broadband remote access servers (BRAS). The switch extracts
access-loop information from the client’s PPPoE Active Discovery Request, and
forwards this information to all trusted ports designated by the pppoe
intermediate-agent trust command. The BRAS detects the presence of the
subscriber’s circuit-ID tag inserted by the switch during the PPPoE discovery
phase, and sends this tag as a NAS-port-ID attribute in PPP authentication and
AAA accounting requests to a RADIUS server.
â—† PPPoE IA must be enabled globally by this command before this feature can be
enabled on an interface using the pppoe intermediate-agent port-enable
command.
Example
Console(config)#pppoe intermediate-agent
Console(config)#
pppoe
intermediate-agent
format-type
This command sets the access node identifier and generic error message for the
switch. Use the no form to restore the default settings.
Syntax
pppoe intermediate-agent format-type {access-node-identifier id-string |
generic-error-message error-message}
no pppoe intermediate-agent format-type {access-node-identifier |
generic-error-message}
id-string - String identifying this switch as an PPPoE IA to the PPPoE server.
(Range: 1-48 ASCII characters)
error-message - An error message notifying the sender that the PPPoE
Discovery packet was too large.
To Next Page
Loading...
Need help?
General