Chapter 24
| Multicast Filtering Commands
MLD Filtering and Throttling
– 724 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld max-groups action replace
Console(config-if)#
ipv6 mld query-drop This command drops any received MLD query packets. Use the no form to restore
the default setting.
Syntax
[no] ipv6 mld query-drop
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command can be used to drop any query packets received on the specified
interface. If this switch is acting as a Querier, this prevents it from being affected by
messages received from another Querier.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld query-drop
Console(config-if)#
ipv6
multicast-data-drop
Use this command to enable multicast data drop mode on a port interface. Use the
no form of the command to disable multicast data drop.
Syntax
[no] ipv6 multicast-data-drop
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/3
Console(config-if)#ipv6 multicast-data-drop
Console(config-if)#
To Next Page
Loading...
Need help?
General