Chapter 24
| Multicast Filtering Commands
MLD (Layer 3)
– 781 –
ipv6 mld This command enables MLD on a VLAN interface. Use the no form of this command
to disable MLD on the selected interface.
Syntax
[no] ipv6 mld
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
MLD (including query functions) can be enabled for specific VLAN interfaces at
Layer 3 through the ipv6 mld command.
Example
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld
Console(config-if)#end
Console#show ipv6 mld interface
VLAN 1 : Up
MLD : Enabled
MLD Version : 2
MLD Proxy : Disabled
MLD Unsolicited Report Interval : 400 sec
Robustness Variable : 2
Query Interval : 125 sec
Query Max Response Time : 10 sec
Last Member Query Interval : 1 sec
Querier : ::
Joined Groups :
Static Groups :
Console#
ipv6 mld last-
member-query-
response-interval
This command configures the frequency at which to send MLD group-specific or
MLDv2 group-source-specific query messages in response to receiving a group-
specific or group-source-specific leave message from the last known active host on
the subnet. Use the no form to restore the default setting.
Syntax
ipv6 mld last-member-query-response-interval seconds
no ipv6 mld last-member-query-response-interval
seconds - The frequency at which the switch sends group-specific or group-
source-specific queries upon receipt of a leave message. (Range: 1-255
seconds)
To Next Page
Loading...
Need help?
General