Chapter 25
| LLDP Commands
– 810 –
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises location identification details.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv location
Console(config-if)#
lldp med-tlv med-cap This command configures an LLDP-MED-enabled port to advertise its Media
Endpoint Device capabilities. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv med-cap
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises LLDP-MED TLV capabilities, allowing Media Endpoint and
Connectivity Devices to efficiently discover which LLDP-MED related TLVs are
supported on the switch.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv med-cap
Console(config-if)#
lldp med-tlv
network-policy
This command configures an LLDP-MED-enabled port to advertise its network
policy configuration. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv network-policy
Default Setting
Enabled
To Next Page
Loading...
Need help?
General