Chapter 25
| LLDP Commands
– 811 –
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises network policy configuration information, aiding in the
discovery and diagnosis of VLAN configuration mismatches on a port. Improper
network policy configurations frequently result in voice quality degradation or
complete service disruption.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv network-policy
Console(config-if)#
lldp notification This command enables the transmission of SNMP trap notifications about LLDP
changes. Use the no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† This option sends out SNMP trap notifications to designated target stations at
the interval specified by the lldp notification-interval command. Trap
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), or organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
â—† SNMP trap destinations are defined using the snmp-server host command.
â—† Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to
detect any lldpRemTablesChange notification-events missed due to throttling
or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#
To Next Page
Loading...
Need help?
General