Edimax EW-7416APn v2 User Manual

8
Chapter II: System and Network Setup
2-1 Installing the range extender/access point to your Network
Please follow the following instruction to build the network connection
between your new wireless range extender/access point and your
computers, network devices:
1. Connect the range extender/access point to ADSL modem, router, or
switch/hub in your network through the LAN port of the range
extender/access point by Ethernet cable.
2. Connect the A/C power adapter to the wall socket, and then connect it
to the ‘Power’ socket of the range extender/access point.
3. Please check all LEDs on the front panel. ‘PWR’ LED should be
steadily on, LAN LEDs should be on if the range extender/access
point is correctly connected to the ADSL modem, router or switch/hub.
If PWD LED is not on, or any LED you expected is not on, please
recheck the cabling, or jump to ‘4-2 Troubleshooting’ for possible
reasons and solution.

Edimax EW-7416APn v2 Specifications

General

2.4 GHz	Yes
Modulation	-
Frequency band	2.4 - 2.4835 GHz
Number of users	- user(s)
Channels quantity	- channels
Networking standards	IEEE 802.11n, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Flash memory	4 MB
Internal memory	16 MB
Processor model	Ralink RT3052
Compatible operating systems	Windows 95/98/ME/2000/XP/Vista
Internal	No
Certification	CE, FCC
Product color	White
Ethernet LAN (RJ-45) ports	1
Security algorithms	128-bit WEP, 64-bit WEP, 802.1x RADIUS, TKIP, WPA, WPA2, WPS
Antennas quantity	2
Antenna gain level (max)	3 dBi
Input current	1 A
AC input voltage	5 V
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	127 mm
Height	30 mm