Check this box to enable Email send.
- SMTP Server: Input SMTP server’s IP address or hostname.
- Port: Input SMTP server’s port number. In most cases it should
be default value ‘25’.
- Sender Email Address: Input the sender’s email address that
will appear in the Email send by IP camera. This will help you to
identify the Email sent by this IP camera, and may help when
you have anti-spam software installed (you can set this Email
address to ‘White List’ in your anti-spam software)
- Receiver #1 Email Address: Input primary recipient’s Email
address. This field is required.
- Receiver #2 Email Address: Input backup recipient’s Email
address. This field is optional.
- Subject: Input Email titles that will appear in the Email send by
IP camera. This will help you to identify the Email sent by this IP
camera.
- Authentication: Check this box when authentication is required
by the Email server you’re using. You also need to input Email
server’s username and password in corresponding field.
- Requires SSL Encryption: If your Email server required SSL
encryption, check this box. Please note that some Email server
uses different port number than standard port 25 when SSL
encryption is used.
- STARTTLS: If your Email server required STARTTLS encryption,
check this box. Please note that some Email server uses
different port number than standard port 25 when STARTTLS
encryption is used.
- Test SMTP: Click this button to test SMTP server settings above
immediately.
To Next Page
Loading...
