EDMI GS-60B - Page 22

GS-60B Residential Gas Meter - Product Guide
Copyright © 2020 EDMI Europe Ltd. All rights reserved
Version / Status: 1.0
Public
PAGE 22 OF 46
Left / Right
No effect.
OK
No effect.
Return
Return to parent menu.
If the supply state is Armed, until a PIN is successfully entered, the screen will show:
Once a valid PIN is entered the screen displays:
Press the OK button to enable the supply.
Once the supply state has changed the screen will refresh displaying the new state.
Note: If uncontrolled gas flow is detected, the following message displays for 10 seconds:
The screen then reverts to:
11.5.6 Join
The Join option allows the ZigBee re-join process to be started in cases where the trust centre has
to be swapped and the automatic retries are infrequent enough to need to be controlled manually.
The Find and Join HAN operation will result in an Event Log entry with User Interface Command
Code 0x001A
11.5.7 HAN Commands
This menu option enables the user to check for any HAN interface commands, added by another
device on the network that are pending collection from the Communications Hub.
On entering the HAN Commands menu, the screen displays:
A
r
m
e
d
E
N
A
B
L
E
?
P
I
N
R
e
q
A
r
m
e
d
E
N
A
B
L
E
?
P
r
e
s
s
O
K
C
A
U
T
I
O
N
S
W
I
T
C
H
O
F
F
A
P
P
L
I
A
N
C
E
S
A
r
m
e
d
E
N
A
B
L
E
?
P
r
e
s
s
O
K