Edwards STP-301 Series

To Next Page

To Previous Page

STP-301/451 Series Instruction Manual

TABLES

Table 3.1 Accessories............................................................................................................3-1

Table 3.2 Accessories for Chemical Specific Pump (Type C)................................................3-1

Table 4.1 Tightening torque of bolt ........................................................................................4-8

Table 4.2 Maximum Torque predicted and Recommended securing bolt

for inlet port flange .................................................................................................4-9

Table 4.3 Number of Claw Clamps by Size of Flange..........................................................4-10

Table 6.1 Connecting the Power Cable................................................................................6-13

Table 7.1 Starting/Stopping the STP Pump during Remote Operation (I/O TB2)...................7-5

Table 7.2 Reset Operation during Remote Operation (I/O TB2) ............................................7-6

Table 7.3 Starting/Stopping the STP Pump during Remote Operation (CON4) .....................7-7

Table 7.4 Reset Operation during Remote Operation (CON4)...............................................7-8

Table 8.1 I/O TB1 Terminal Block ..........................................................................................8-1

Table 8.2 Rated Contacts for Relays CR1, 3, 5, 7, and 8 ......................................................8-4

Table 8.3 Rated Contacts for Relays CR4 and 6 ...................................................................8-4

Table 8.4 I/O TB2 Terminal Block ..........................................................................................8-5

Table 8.5 CON4 Connector (Remote Input Signal)................................................................8-7

Table 8.6 Rated Coils for Relays CR1, 2 and 3 .....................................................................8-8

Table 8.7 CON 4 Connector (Remote output signal)..............................................................8-9

Table 8.8 Rated Contacts for Relays CR4, 5, 6, 7, 8, 9 and 10 ...........................................8-11

Table 8.9 Remote Cable Connections (Single-Side Connector Type) .................................8-11

Table 10.1 States of Lamps and REMOTE Output Signals at Power Failure ........................10-2

Table 10.2 Operations of the STP Pump after Power Recovery ............................................10-2

Table 10.3 Safety Functions ..................................................................................................10-4

Table 11.1 Error Messages....................................................................................................11-3

Table 11.2 Troubleshooting after Powering ON .....................................................................11-7

Table 11.3 Troubleshooting When Performing the STP Pump Start Operation .....................11-7

Table 11.4 Troubleshooting While the STP Pump is Rotating ...............................................11-8

Table 11.5 Recommended Spare Parts ...............................................................................11-10

Table 11.6 Cleaning and Decontamination ..........................................................................11-11

Table 13.1 Specifications of the STP Pump...........................................................................13-1

Table 13.2 Specifications of the STP Control Unit .................................................................13-5

Edwards STP-301 Series - Page 12